Products Catalogue • Laminated particle boards

Laminated lumber-core boards are manufactured on the basis of particle boards. Ground boards are covered with laminated film from upper and down surfaces. The use of laminated boards in furniture manufacture allows realizing multitudinous designers’ ideas, manufacturing furniture of any style, satisfying requirements of customers various categories. We offer a wide range of colours and structures of board surfaces (see Products Catalogue for more information).

Specification Chart

Packaging of pallets
format 2440х1830

THICKNESS, mm	QUANTITY of boards	WEIGHT, kg gross	WEIGHT means of packing, kg
8	25	731,9	80
10	25	883,7	80
12	40	1580,3	80
16	30	1537,4	80
18	25	1426,3	80
22	25	1676,3	80
25	20	1508,9	80
28	20	1655,3	80
32	20	1851,8	80
36	15	1550,8	80
38	15	1632,6	80

Packing means:

particle board bar (1830х80х16) 15pcs
particle board bar (1830х120х16) 3pcs
packaging steel strip/PUF coating (16х1)
nails
particle board backing plate (2440х1830х16) 1pcs

Total weight 80kg

Packaging of pallets
format 2800х2070

THICKNESS, mm	QUANTITY of boards	WEIGHT, kg gross	WEIGHT means of packing, kg
8	25	954,4	108
10	25	1137,0	108
12	40	2055,6	108
16	30	1944,4	108
18	25	1803,5	108
22	25	2180,3	108
25	20	1969,9	108
28	20	2153,0	108
32	20	2407,7	108
36	15	2017,4	108
38	15	2122,5	108

Packing means:

particle board bar (2070х80х16) 20pcs
particle board bar (2070х120х16) 4pcs
packaging steel strip/PUF coating (16х1)
nails
particle board backing plate (2800х2070х16) 1pcs

Total weight 108kg

MANUFACTURE OF PARTICLE BOARDS

STANDARDS REQUIREMENTS
within thickness of 0.8 mm to 38.0 mm

No.	Parameters	Standards’ Value
1	Thickness, mm	8	10	12	16	18	22	25	28	32	36	38
2	Density (kg/m³)	730	720	700	680	670	650	640	630	620	610	610
3	Bending (МРа)	14	14	14	13	13	11,5	11,5	10	10	8,5	8,5
4	Unbending (МРа)	0,4	0,4	0,4	0,3	0,3	0,3	0,3	0,24	0,24	0,2	0,2
5	Exterior layer breaking off (MPa)	>0,6
6	Swell on wetting 2 hours	up to 8% (22% 24hours)
7	Free formaldehyde content	up to 8,0mg / 100g of dry mass
8	Mineral deposits content	<0,2%
9	Humidity	5% to 11%
10	Thickness tolerances	0,3; ±0,5mm						±0,5mm
11	Length and width tolerances	±0,5mm
12	Deviation from edge straightness	<2,0mm/m
13	Deviation from right angle	<2,0mm/m
14	Surface resistance to acid impact	3 level
15	Surface resistance to contamination	3 level
16	Surface resistance to high temperature	3 level